Hnkrader

Hello everyone, I recently got my kraken turbo kit in and I had a few questions about stuff on the turbo. It's a .72ar t25 IWG turbo, so the IWG stuff is mainly what I wanted to ask some questions about.

Here's my questions:

1. What size hose should I need to fit onto the wasgate nipple?
2. Where can I buy a 90° fitting for my wastegate boost source? Im not quite sure what id look up to find it
3. How do I set IWG preload, and how should I know if it's too much or too little?

I'll provide some pictures of the turbo below

Photos:

The little hex head near the compressor is where my wastegate boost source would go, but im not sure what size thread it is, im assuming a 1/8\" NPT.

Same question about the nipple size on the wastegate, jm assuming 1/8\".

shuiend

iTrader: (24)

You run a vacuum line from the coldside IC pipe to the wastegate. You leave the port on the turbo closed.