Turbo Tony DP What size bolts?
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2007
Location: Western N.C.
Posts: 446
Total Cats: 1
Turbo Tony DP What size bolts?
I just received my used turbo Tony down pipe, the flange is considerably thinner then the greddy flange. Due to the difference of thickness, I doubt I will be able to retain the old bolts. So my question is, what size, length, and thread pitch bolts will I need to install the turbo Tony down pipe?
#5
i wouldn't recommended reusing the stock hardware as it should have been upgraded from the start. You should go to a stud and nut combo. With that being said you will be fine if you want to reuse the stock stuff. The bolt holes that hold the downpipe to the exhaust housing on the turbo are straight through so they wont bottom out if the flange is thinner.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM