When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
First up, a quick fit test I printed. The duct can easily be installed in the back of the lip without needing to remove it. There are 5 holes countersunk for m5 bolts and it wants to stay registered to the lip on its own. If the tube is zip tied and supporting it's own weight these 5 holes should be all that is needed.
After printing the fit test I made a few small tweaks. I think this is the final design:
Last edited by WrenchGame; 02-19-2018 at 04:32 PM.
Looks great! I bet you could do away with the 5th hole and delete the center bottom one. Also, if you then stack the other four holes vertically, that would make it much easier to drill all holes from underneath the car and just go through both sides of the duct. Stoked to see the R package version!
These prototypes look great. Will there be separate files for the inlet and outlet? Very interested to get my hands on a set. Starting to shop for Singular brake ducts and hose
Ill be printing the beta today and hopefully fitting to my NA sometime this week. If everything goes well there, then ill start experimenting with how to best print it for strength, and order some hardware and put some kits together. Default color will be black(I might take requests), I might experiment with vapor bathing.
02-19-2018, 10:31 AM
3
