please let me know if there will be more where this came from.

 

Possibility of a group buy soon: Very possible
Possibility of doing a GB with low prices like this one: Extremely unlikely

 

any news on the MS?

 

Go back one page and read I believe it is post #37. He gave an update yesterday.

 

Wow that was fast from Greece.

It arrived this morning. Usually my US shipped items take much longer than this.

I'll PM you for the additional steps

 

A little update:

I never told you guys but I created a board to make these V3 Megasquirts as good as possible, with features such as full sequential injection, A/C idle up, boost control, optoisolator on the cam input, 1% hardware resoluton on the idle valve signal, etc.

Unfortunately, there was a problem with the boards and they were unusable. So I had a not so fun weekend building similar custom boards from scratch, removing the defective boards and I'm already half-way through installing the new boards. I need about two days to call it done.

Pics of the custom board that has no hardware idle up, and one of the defective boards:

 

would you be selling this god like daughterboard separately?

i am already building my MS2 for my FWD BP but this would make it rock solid..

 

I'm sure he'd sell them for cheap...

 

They are defective and can't be fixed. Want 10 of them?

 

So sorry! I hope this didn't eat up too much of your profit for the travel. If so, did notice there were a few people who want one and were too late!

I do appreciate the special attention with the ac etc.

 

About $150 for all of the 10 boards. I went cheap and got them without a soldermask or a silkscreen. If I hadn't, it would have been worse.

 

I ment the revised boards..

 

There won't be any revised boards, this was a one-off batch for this group buy. It would have cost me the same to get either 5 or 10 boards.

 

 

Tell me about it!

 

dang, just got caught up on ur prob. sry to hear that rev. props for spending your weekend sorting it out tho

 

thanks for your hard work boss!

 

Main units fully assembled. Time to prepare the harnesses. Everyone, please answer your PMs, this is the last step before getting your units loaded with the proper basemaps and sending them out.

 

DriftProjectR, please answer your PM! I can't finish your unit unless you answer.

 

sent you a pm!