Running ACT ZM1-XTSS clutch, which flywheel should I run
Thread Starter
Junior Member
Joined: Sep 2018
Posts: 86
Total Cats: -1
Running ACT ZM1-XTSS clutch, which flywheel should I run
So I’m installing a ACT ZM1-XTSS clutch on my 250hP turbo Miata. I am not sure what the torque is currently on the car.
Just curious with those of u who have run this clutch, what kinda of fly wheel did you run with it? Stock or lighter?
Again the cars turbo’d an it’s basically a daily driver. No canyon runs, a lot stop an go traffic, probably auto cross the car later this year.
Just curious with those of u who have run this clutch, what kinda of fly wheel did you run with it? Stock or lighter?
Again the cars turbo’d an it’s basically a daily driver. No canyon runs, a lot stop an go traffic, probably auto cross the car later this year.
Reply
0
0
Thread Starter
Junior Member
Joined: Sep 2018
Posts: 86
Total Cats: -1
I’ve been searching, a lot of people ran a 1.8 stock fly wheel with my setup. I’m leaning towards that.
My miata is a 1.6 with the XTSS, will I have any issues putting a 1.8 fly wheel in a 1.6 XTSS clutch?
i also read about lightening a 1.8 stock fly wheel? What’s that about ?
My miata is a 1.6 with the XTSS, will I have any issues putting a 1.8 fly wheel in a 1.6 XTSS clutch?
i also read about lightening a 1.8 stock fly wheel? What’s that about ?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
