sending mspnp in for Warrnty work, question
#1
Bannisheded
Thread Starter
iTrader: (33)
Join Date: Jan 2009
Location: San Jose, CA
Posts: 1,056
Total Cats: -3
sending mspnp in for Warrnty work, question
so i just got the new motor in and i think while removing the engine before i grounded the POS starter wire to the frame and it fried my MSpnp's fuel pump circuit.
so i wanted to ask while the MS is getting serviced can i switch it back to stock ecu and afm
its a 93 1.6
i put the stock injectors and ecu back in.
i want to break in the new motor like this till the MS comes back then everything will be tuned. obviously i cant rev high since i,ll be breaking the engine in so wondering if its ok to do this.
the 2554 is hooked up and all lines too .
thanks
so i wanted to ask while the MS is getting serviced can i switch it back to stock ecu and afm
its a 93 1.6
i put the stock injectors and ecu back in.
i want to break in the new motor like this till the MS comes back then everything will be tuned. obviously i cant rev high since i,ll be breaking the engine in so wondering if its ok to do this.
the 2554 is hooked up and all lines too .
thanks
#2
Tour de Franzia
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
break-in takes minutes. Just wait for it. Seriously, just pull full vacuum, do some 100kpa pulls, then hook it up and drive it. I wouldn't track it the first day, but after about 1000miles, its race-ready.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM