I finally managed to get the Emanage blue hooked up to my ECU and have a couple of problems. Firstly, it will only fire up if I remove the Emanage ignition harness. I originally cut ignition 1 and 2 on the harness and connected them as per the instructions, but it won’t fire up. The instructions say:

Ignition 1 - blue/white wire to ECU
blue/black wire to Sensor

Ignition 2 - Orange/white wire to ECU
Orange/black wire to Sensor

Am I missing something? Am I correct in saying that there are only 2 ignition points on the ECU harness? The second problem I have is that the car will start up and then immediately cut out, can anyone tell me what the problem might be? Everything is fine once I remove the Emanage.

BTW - my car is a 1997 Mk1 (NA) 1.8.

 

I disconnect the wiring to the MAF and that allows the engine to run. I have larger injectors to go on so I take it I will need to run the MAF to the Emanage some how? Does anyone have any idea why I cant use the ignition harness?

I will also want to data log using my AEM wide band how do I connect this?

 

I still cant get the emanage to run with the MAF wire connected or it to run with the ignition harness wired in. I hooked my lap top up and made sure evrything was zero'd and that the main unit was updated. I am using version 1.49 of the software.

Does anyone have any idea of what else maybe wrong?

 

This is what I get when I load up the support tool'



I just cant seem to run the ignition harness and am at a total loss as to why its not working. I've gone through and checked every wire a dozen times and gone over the ECU pinouts countless times.