this may sound like a silly question but could i use the signal from my EMB map sensor as an input to my zeitroniz wideband rather than buying there specific sensor?

 

So I assume you are asking about taking the feed from say a gm 2-bar map sensor, which you are feeding into the emb, and share it with the WB?

Well it shouldn't have a problem, but you might want to check your voltages on both if you can, to make sure that the extra wiring isn't changing any numbers etc....

Dave,

 

its not a gm sensor its the greddy sensor that is hooked up to the emb. just wondered if anyone knew if that sensor and the specific zeitroniz sensor were compatible so i could use the 1 sensor to provide signals to both my emb and the boost input to my zeitroniz wideband. would save some wiring and some cash on another sensor.