Oil Squirters in 1.6
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2011
Location: Orlando, Fl
Posts: 57
Total Cats: -16
Oil Squirters in 1.6
In the middle of rebuilding my motor i was unsure if the machine shop tightened my oil squirters so I tried to pull them and broke one. Any suggestions, should I pull and tap it? Where can i find another bolt? I need to finish this motor in 10 days I'm moving to Florida any help would be great thanks.
#3
Senior Member
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
ok i heard that some machine shops will remove the squireters when installing aftermarket pistons due to the skirt comes in contact with the squirter, i think one of the advantage to Flyin Miata pistons is that they can be used with squirters due to they clearance the sleeve for them. Maybe someone with more knowledge can chime in. If needed i can mail you a squirter on Tuesday.
#8
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2011
Location: Orlando, Fl
Posts: 57
Total Cats: -16
I have wiseco pistons eagle rods both forged should I plug them? It took me 20 min to describe what they were to the Mazda dealership in my area and the bolt alone cost $26 and will take 2 days to get here.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM