Well i sent my head out to BogusSvo to replace some valve stems that where cut when the port job was done, also had him clean up the ports, cut the throats, set the proper seat pressure with the Webb cams and i think he said he did something to the combustion chamber? Maybe he will chime in on here.

 

As stated this was a miata head, im not sure if there is much difference between the b6t and miata head if any, One question i have though is the previous owner plugged one of the coolant passages on the back of the head there use to be a rubber stop plug in it. Well it looks like Dale may have just put a freeze plug in where the rubber stop was, With me putting this in a front wheel drive i should remove that freeze plug correct?

 

Did he send you his old camera too?

 

FESTIVA POWERRRRRRRRRRRRR!!!!!111

specs on cams? the plug on the back is probably for the heater or the oil cooler hoses

 

the cams came with the car, but they have .505 engraved on them so i think its this.
http://www.webcamshafts.com/pages/au...89_002493.html
?
Its got Super tech 1+mm valves, Super tech valve springs and hardware.

 

that's some ***** lift