I bought a greddy turbo with no oil lines, as others have. yes, I have searched, but, since I don't always turst my reading comprehension, here is what I am ordering:

for drain, easy, JGS kit, as seen here. (td05 kit) Far as I can tell I don't need anything else for this.

For the feed line, I'd love to order a similar kit, are any of the JGS kits here sufficiant?

Other option seems to be order piecemeal from summit:

EAR-921104ERL
Fitting, Coupler, 90 Degree, Female -4 AN to Male -4 AN, Aluminum,
$11.95

EAR-9919BFCERL
Fitting, Adapter, AN Flare to Metric, -4 AN to 10mm x 1.25 Male, Aluminum,
$10.69

EAR-9919BFDERL
Fitting, Adapter, AN Flare to Metric, -4 AN to 10mm x 1.5 Male, Aluminum,
$10.69

NOS-15240NOS
Hose, Braided Stainless Steel, -4 AN Female End, Blue/-4 AN Female End, Blue, 36 in. Length,
$28.39

Sub Total: $61.72


This puts the cost of my oil lines at well over $100....seems like a bit much, especially the feed line at over 75 shipped. Yes, I will be using a drilled/tapped oil pan.

 

Sounds like you did well. You'll never be second guessing that oil line setup.

 

teflon inner lines pwn all. rubber sucks

 

er, were any of the lines I posted rubber, or was that just a general statement magna? :-)