6-Rib Setup
#6
Sorry for the delay @gthill13...
1. This thread is pertinent: https://www.miataturbo.net/superchar...install-89965/
2. BRP Installation instructions for 6 rib are attached to this post.
1. This thread is pertinent: https://www.miataturbo.net/superchar...install-89965/
2. BRP Installation instructions for 6 rib are attached to this post.
Last edited by bahurd; 02-09-2017 at 11:15 AM.
#7
Sorry for the delay @gthill13...
1. This thread is pertinent: https://www.miataturbo.net/superchar...install-89965/
2. BRP Installation instructions for 6 rib are attached to this post.
1. This thread is pertinent: https://www.miataturbo.net/superchar...install-89965/
2. BRP Installation instructions for 6 rib are attached to this post.
#10
I havent seen an update to this for a while so I hope it came together. My dad and I installed a BRP 6 rib in my recently. Happy to assist with photos, advise, etc. We are by no means experts, but that may be advantageous; from one novice to another. You can see bits and pieces here or a full write up on mostlymiata.net. Feel free to email me as well: mattevandavis@msn.com
#12
Here is a link to our page: BRP M62 Supercharger Install - Mostly MIATA
There are 10 sub pages. Just let me know what we can do to help.
There are 10 sub pages. Just let me know what we can do to help.
#13
Here is a link to our page: BRP M62 Supercharger Install - Mostly MIATA
There are 10 sub pages. Just let me know what we can do to help.
There are 10 sub pages. Just let me know what we can do to help.
I am putting the blower in the car today. Hopefully not too many issues.
#15
Would love to see your new intake setup when its done. I was using the flex hose, but it moved too much, causing holes when it'd rub. Even at only 11psi, when I tried switching to Silicone tubes, they'd collapse under vacuum caused by the SC. I spliced in aluminum couplers every few inches for strength. it's been hard to find 3" intake piping with tight bends though to avoid the firewall and double-back under the hood. Right now I'm using Frankenstein setup of all three and still get holes from rubbing.
I may have to go with a custom welded inlet tube, I guess.
I may have to go with a custom welded inlet tube, I guess.
#16
Would love to see your new intake setup when its done. I was using the flex hose, but it moved too much, causing holes when it'd rub. Even at only 11psi, when I tried switching to Silicone tubes, they'd collapse under vacuum caused by the SC. I spliced in aluminum couplers every few inches for strength. it's been hard to find 3" intake piping with tight bends though to avoid the firewall and double-back under the hood. Right now I'm using Frankenstein setup of all three and still get holes from rubbing.
I may have to go with a custom welded inlet tube, I guess.
I may have to go with a custom welded inlet tube, I guess.