1995 Diff Swap - Axle Flange Removal
#1
Senior Member
Thread Starter
Join Date: Jun 2022
Location: Aliso Viejo, CA
Posts: 895
Total Cats: 182
1995 Diff Swap - Axle Flange Removal
Doing a 3.6 diff swap into my 1995, which I didn't realize has the older style diff to axle shaft flanges like the NA6 - I'm going to need to transfer these over as my 3.6 didn't come with axle shafts.
Do these just press out? I got a decent size prybar on them and couldn't make them budge. Just want to make sure before I take the air hammer to them.
Thanks as always.
-Zak
Edit: Disregard this post. Didn't realize I also need the axles out of a 96-05'
Do these just press out? I got a decent size prybar on them and couldn't make them budge. Just want to make sure before I take the air hammer to them.
Thanks as always.
-Zak
Edit: Disregard this post. Didn't realize I also need the axles out of a 96-05'
Last edited by Z_WAAAAAZ; 02-27-2024 at 11:24 AM.
#3
Senior Member
Thread Starter
Join Date: Jun 2022
Location: Aliso Viejo, CA
Posts: 895
Total Cats: 182
This is the exact type of sh*t that I would run into Ten bucks says I'm also about to find out I've been running an open diff for the last two years lol.
Sounds good, I'll try to pop one out and see if it fits into my new diff. For science.
Sounds good, I'll try to pop one out and see if it fits into my new diff. For science.
Thread
Thread Starter
Forum
Replies
Last Post