spindle bolt stuck?
#1
Junior Member
Thread Starter
iTrader: (6)
Join Date: Jun 2011
Location: Bonita springs florida
Posts: 348
Total Cats: -107
spindle bolt stuck?
I'm in the process of doing a rear subframe swap. The bolt that goes thrue the lower hotel arm and holds the spindle to it. I you'll the nut off the rear...and i can't seem to get it out. Is there anything else holding the thing in there? Out can i just give it hell with a bfh?
#2
I'm in the process of doing a rear subframe swap. The bolt that goes thrue the lower hotel arm and holds the spindle to it. I you'll the nut off the rear...and i can't seem to get it out. Is there anything else holding the thing in there? Out can i just give it hell with a bfh?
#3
If I can understand the abomination of a post above it appears you are trying to remove the bolt from the lower control arm on the outboard end. Yes, it will come out. It's probably corroded in place. Spin it with an impact wrench to clean it off or put the nut back on to protect the threads and tap it out with a hammer.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM