Is my new throw out bearing ok?
#1
Is my new throw out bearing ok?
Hey hey.
Waiting on a flywheel frictiom diac but getting ready to mate my gearbox and engine. Have a new clutch kit, supermiata sport, organic faced. Is an NTN TOB, so should be good ****.
Was about to mount the TOB on the arm and I noticed the internal guide sleeve is not concentric.
It appears the plastic guide sleeve is almost touching the inner race on one side, eyeballing <1mm and on the other side looks to be ~3mm
I am assuming this is what holds the bearing perpendicular to the fingers and if this guide tube is crooked, it may not press on the fingers evenly?
Or am I overthinking this and send it?
thoughts appreciated
Thanks!
Waiting on a flywheel frictiom diac but getting ready to mate my gearbox and engine. Have a new clutch kit, supermiata sport, organic faced. Is an NTN TOB, so should be good ****.
Was about to mount the TOB on the arm and I noticed the internal guide sleeve is not concentric.
It appears the plastic guide sleeve is almost touching the inner race on one side, eyeballing <1mm and on the other side looks to be ~3mm
I am assuming this is what holds the bearing perpendicular to the fingers and if this guide tube is crooked, it may not press on the fingers evenly?
Or am I overthinking this and send it?
thoughts appreciated
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
cmalouf
Suspension, Brakes, Drivetrain
19
09-24-2013 12:03 PM