WTB: Crankshaft pulley bolts (4 - 10mm)
Thread Starter
Elite Member
iTrader: (11)
Joined: Jun 2007
Posts: 2,065
Total Cats: 1
From: Meriden, CT
WTB: Crankshaft pulley bolts (4 - 10mm)
The bolts that were in there were not the high grade ones and after snapping one (I was able to get it out with some needle nose pliers) I decided to pull them all and get the correct high grade fasteners (10.9 or 12.9). If anyone has some laying around please let me know! Thanks
On another note, does anyone know the size proper size for these bolts? I'm thinking 10mm X 1.5 X --mm 10.9 or 12.9
On another note, does anyone know the size proper size for these bolts? I'm thinking 10mm X 1.5 X --mm 10.9 or 12.9
Last edited by Cspence; Dec 28, 2010 at 10:56 PM.
Reply
0
0
I've had no issues after replacing a few snapped bolts (I'm built like the ******* hulk) with any of the other short 6mm bolts that are everywhere on the car. Could be blind luck though.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
Sep 12, 2016 08:17 PM
