WTB NB Rear O2 Sensor
Thread Starter
Junior Member
iTrader: (4)
Joined: Dec 2014
Posts: 152
Total Cats: 63
From: Phoenix, AZ
Looking for a rear O2 sensor for my MSM. I lost the original that was removed when I went to MS, and I have emissions coming up later this year.
Obviously, I'm looking for a functioning part so I don't have a CEL after I go back to the stock ECU for the inspection. Let me know what you've got.
Obviously, I'm looking for a functioning part so I don't have a CEL after I go back to the stock ECU for the inspection. Let me know what you've got.
I believe I have one, I bought a car in pieces in a box so i'm not sure if its front or rear but its from an 2004 mazdaspeed. I'd give it to you free if you pay shipping! Can you post a connector pic and estimated length?
Thread Starter
Junior Member
iTrader: (4)
Joined: Dec 2014
Posts: 152
Total Cats: 63
From: Phoenix, AZ
Connector is 4 pin in a square pattern. I took a photo of the front one, but rear should be the same (pretty sure the harness end of it is under the seat and carpet, from memory).
It's about 3 feet long and had a grommet integrated to the wire to pass through the body, and at least 1 P-clamp to hang the wire along the run of the exhaust pipe.
Thanks!
It's about 3 feet long and had a grommet integrated to the wire to pass through the body, and at least 1 P-clamp to hang the wire along the run of the exhaust pipe.
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post





