I'm looking for some VVT motor pigtails: the VVT actuator connector w/ wires, both connectors for the crank- and camsensors with and wires.

VVT motors are nearly impossible to find here, let alone the harness parts.

Let me know if you have them/can source them and stuff 'm in a flatrate envelope.

Edit: Furthermore, I'm also looking for rods, 949 SUB lifters, ARP headstuds and an BE oilpump. If you have any of these too in (near) new condition, hit me up.

Thanks, x0x0

 

Found the CMP and CKP connectors/wires on an old NB 1.6 loom I still had apparently. Still need the VVT actuator connector/pigtail and any go-fast parts mentioned above.

Have squaretop to trade

 

Can you not buy a new VVT connector? In the connector witch hunt thread I am pretty sure we have the part numbers for them.

 

I could, but I'd still need to source them in the US, dick around with minimum order quantity, the right pins etc. It'd be easier if someone had a spare loom that they could send me.

 

Bump

 

Pump found, still looking for VVT pigtail, rods, ARP headstuds and SUB lifters.

 

Sell me your **** damnit

 

I will check the three or four harnesses I have and see if I have that plug. I will let you know.

 

Thanks, much appreciated.

 

Can you still get Flat-top manifolds?

 

I could ask around. I sold my spare one and have one that is going to be used on my news motor.

 

Anyone?

 

Bumpity bump

 

You're shitting me, no one with a spare harness and some pliers willing to do me a solid?

 

Should just go the route I suggested. You would have had them by now. Have you checked out the parts group?

 

Like I said, either I need to buy 50 connectors at least, pay $100 for a padded envelope with a connector or buy connector and pins from two separate vendors because they don't have both in stock. Or any of those combined.

I am this close to throwing this VVT **** in the bin and just build my spare 99 head.