Faelflora breaks his promise, time to part out car. GIT THE SAWZALL!
#2446
Slowest Progress Ever
iTrader: (26)
Join Date: Oct 2007
Location: The coal ridden hills of Pennsylvania
Posts: 6,025
Total Cats: 304
#2454
Elite Member
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Location: Los Angeles, CA
Posts: 8,682
Total Cats: 130
I'm having trouble getting the boost control to work properly.
I bought and installed a grimmspeed. Everything is ok in a WOT run in gears 1-3 but on 4/5 boost spikes and oscillates and doesn't settle down. Same oscillation/spiking if I WOT from a cruising speed on the highway.
I was using your turbo dynamics and wastegate duty cycle settings but no go.
I'm thinking about zeroing out turbo dynamics and trying to get boost working properly with just wastegate duty cycle.
Quite a pain in the *** to just run 17psi.
Five-o 1200s? Are these better than the fuel injector clinic injectors?
These???
http://www.fiveomotorsport.com/1200c...-low-impedance
And yes, I did run out of injector in the forester.
#2455
16g must be doing its job properly then.
either ones will work, as long as they're side feed.
if you're having this much trouble with boost control, and it is very finicky and takes a good amount of time to dial in dynamics, primary wgdc, max wgdc, etc, then just slap on an mbc and call it a day.
Had one on my 07 rex back in the day with a 18g and a 20g and worked like a champ.
Get a Hallman pro-RX, dial in within 2 minutes, and never have to worry about it again.
Just make sure you have boost cut enabled and working right or you'll be in the market for yet another forester
either ones will work, as long as they're side feed.
if you're having this much trouble with boost control, and it is very finicky and takes a good amount of time to dial in dynamics, primary wgdc, max wgdc, etc, then just slap on an mbc and call it a day.
Had one on my 07 rex back in the day with a 18g and a 20g and worked like a champ.
Get a Hallman pro-RX, dial in within 2 minutes, and never have to worry about it again.
Just make sure you have boost cut enabled and working right or you'll be in the market for yet another forester