Atlanta93LE

iTrader: (5)

Any ex-DSM guys here have a source (preferably cheap) for a compressor outlet flange for a stock DSM turbo, i.e. 14b/16g, etc. Even better would be an outlet adapter that steps up to 2". Should I just cut the flange off a stock outlet pipe and weld on a transition from 1.5" to 2"? Thanks

nester

iTrader: (6)

I may have one at the shop, I can check tomm if you remind me...

mazda/nissan

iTrader: (2)

you mean a J-pipe right? Ebay has the flanges for $14.99 with free shipping

eBay Motors: 16G TD05 DSM Turbo FLANGE + GASKET J-Pipe Charge Pipe (item 260347742979 end time Jan-22-09 19:41:49 PST)

Atlanta93LE

iTrader: (5)

^ Yep, saw those; hoping to spend less than $15 though. Thanks

skidude

iTrader: (3)

$14.99<$15.00... Free shipping means you only pay $14.99.

wildfire0310

iTrader: (1)

I may still have a stock J-pipe from my good old DSM days. I won't know until friday when I go back to the storage unit.

As for cheaper the one posted is about the cheapest your going to get it. That J-pipe isn't a cheap part.

Pseudosport

iTrader: (9)

I made mine out of a stock J-pipe flange and a piece of Dodge 440 header. The stock flange is thin and was brazed to the pipe. This made welding a little more difficult. If I was to do it again I would spend the money and buy a flange.

here's a pic of my set up

elesjuan

iTrader: (11)

That what you're after?? Pay the cheapest shipping I can find for it, and its yours.

Atlanta93LE

iTrader: (5)

Thanks for the warning/tip.

Considering the above, I'll probably buy a flange. Thanks though

elesjuan

iTrader: (11)

I'd just buy the flange myself, but lemme know if you still want that pipe.

On second thought, don't buy that stainless POS on ebay, contact Weir and get a good one..