Differences in wiring harnesses (harni?)
#1
Elite Member
Thread Starter
iTrader: (7)
Join Date: Apr 2006
Location: VaBch, VA
Posts: 6,451
Total Cats: 322
Differences in wiring harnesses (harni?)
Anyways, I think I'd like an unmolested main wiring harness for my MS install at some point in the future. My car is a '93 Cali. Is there anything special about it? Does anybody have a pic of the harness out of the car? What would it take to pull my old harness and install a new one.
I really buggered up the splicing/soldering when I installed my Bipes/02 clamp, so whatever the minimum I need to swap out in order to get that stuff back to originial is what I'm looing for.
I really buggered up the splicing/soldering when I installed my Bipes/02 clamp, so whatever the minimum I need to swap out in order to get that stuff back to originial is what I'm looing for.
#2
Honestly I don't think it's worth the work or risk. Think of it this way- your harness is working now. It would suck to go through all the work (lots of it) only to get it all hooked up and find out something is wrong. Then you'd have to sort that out before even getting to the MS install. IMO - don't fix it unless it's broke applies here. The 93 Cali is wired for sequential injection whereas the rest of the other states were not.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM