budget exhaust?
#1
Elite Member
Thread Starter
iTrader: (17)
Join Date: Apr 2009
Location: Atlanta, GA
Posts: 2,799
Total Cats: 1
budget exhaust?
i remember reading something on the forum about a cheap route to go on a 3" exhaust...if i remember correctly it had something to do with some pre bent 3" SS piping.
i have been searching the forum for a couple hours now and i havnt turned anything up!
now as far as my setup goes i will running a BEGI SG downpipe and a metal core cat! for the cat back i simply want to do a 3" exhaust all the way to the back with no resonators or mufflers!
can anybody give me some leads to go on?
i have been searching the forum for a couple hours now and i havnt turned anything up!
now as far as my setup goes i will running a BEGI SG downpipe and a metal core cat! for the cat back i simply want to do a 3" exhaust all the way to the back with no resonators or mufflers!
can anybody give me some leads to go on?
#6
Elite Member
Thread Starter
iTrader: (17)
Join Date: Apr 2009
Location: Atlanta, GA
Posts: 2,799
Total Cats: 1
i tried searching for pre bent pipe on ebay......but my search didnt end up to well. what kind of steel did you use for the exhaust?
on a side note, props on all your fab work! looks very very good....and clean.
#7
Elite Member
Thread Starter
iTrader: (17)
Join Date: Apr 2009
Location: Atlanta, GA
Posts: 2,799
Total Cats: 1
i dont really have a budget, i just said budget in the title cause it sounds better than cheap! i want stainless because my downpipe is stainless. but the alumized steel can be put into consideration........
#9
Sean.... please step away from the exclamation (!) key...as a matter of fact, just remove the 'shift' key from your keyboard so you will not be tempted to use it.
Summit carries a generic 3" exhaust kit of aluminized steel.... i'll go in on half with you since half the "kit" will probably do one Miata...and you can pick it up directly from them.
FLO-15937 Flowmaster 15937
Flowmaster 15937 - Flowmaster U-Fit Dual Pipe Kits
Summit carries a generic 3" exhaust kit of aluminized steel.... i'll go in on half with you since half the "kit" will probably do one Miata...and you can pick it up directly from them.
FLO-15937 Flowmaster 15937
Flowmaster 15937 - Flowmaster U-Fit Dual Pipe Kits
#11
Elite Member
iTrader: (7)
Join Date: Jan 2007
Location: Renton Washington
Posts: 1,731
Total Cats: 4
Or you can support our forum sponser Tube Bending & Fabrication - Columbia River Mandrel Bending
Recieve extra discount
Discount code for Miata turbo members : MT5M
Recieve extra discount
Discount code for Miata turbo members : MT5M
#16
Elite Member
Thread Starter
iTrader: (17)
Join Date: Apr 2009
Location: Atlanta, GA
Posts: 2,799
Total Cats: 1
Mike, ill keep the summit thing in mind.
if i do go the summit route ill be getting mild steel, so that way i can weld it myself.
back of my punctuation! haha
i did look through Columbia River Mandrel Bending but i only looked at there stainless piping.
if i do go the summit route ill be getting mild steel, so that way i can weld it myself.
back of my punctuation! haha
i did look through Columbia River Mandrel Bending but i only looked at there stainless piping.