So as I have ac lights wipers and radio on car started reving higher up and down around 2k now jumped up to 3500 and stuck. Tun off turn on stuck at 3500 no matter what I turn on or off

K pulled temp sensor still runs whitout a beat pullied mani pressure ocilates but stays on.

You'll need your laptop to diagnose but check your TPS readings. With the car off, make sure your TPS reading is '0' at closed and '100' at full open, cycle the pedal a few times to make sure. Then turn the car on, if the TPS window registers '1' or higher at idle (assuming the car is idling at 3500RPM), there's your problem.

If it's doing this, adjust the Throttle Closed numerical value up in the Hydra settings (until the TPS closed reading is '0') and the car should operate correctly.

From the Hydra manual:

So how do I get into these tps reading window Jeremy was telling me about this from flyin miata

You need a computer with the Hydra software loaded onto it that you will hook up to the Hydra. If you have your manual, it will walk you through all this.

so I see it in the mode screen under the first map screen.

If by mode screen you mean the main screen you see after you upload your current map from the ECU, then yes, that is where you see the TPS window (which is at the bottom left).

This is an old screenshot of the main screen, but you get the idea:

Attached Thumbnails

 

reading the manual now from flyin miata

Good. I think pages 9 and 10 cover adjusting the Throttle Position Sensor and calibration.

spek engleshe plz

So I was told that this number can go up or down and I can adjust a number 2-3 points over what it is what and where would I do this in the throttle screen?