Videos: post your diy junk in action
#2
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Atlanta
Posts: 7,486
Total Cats: 372
90 Miata FE-dohc 2.0L t3/t4 48AR Stage3 60AR 50 trim 9psi
Intention was to log some closed loop boost control, but couldn't get the map to "stick". So all the vids are at 9psi. Tach is off by about 800 rpm up top. Yes, sound/wind noise = me That was with tape covering the entire mic port. Next time I'll tape foam over the port. Cam also has an external a/v in port, so I might try and see if it'll take just audio in... tho I doubt it, probably switched.
----------------------------
Was headed out to a big road that's dead this time of night, though that wasn't the case tonight... massive jam up. So I stayed near home. This was starting in 2nd at 2k and on through 3rd.
----------------------------
This is 1st gear from an idle roll, through 2nd.
----------------------------
3rd gear from 2k rpm
----------------------------
1st-4th from roll
----------------------------
Was headed out to a big road that's dead this time of night, though that wasn't the case tonight... massive jam up. So I stayed near home. This was starting in 2nd at 2k and on through 3rd.
----------------------------
This is 1st gear from an idle roll, through 2nd.
----------------------------
3rd gear from 2k rpm
----------------------------
1st-4th from roll
#12
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Atlanta
Posts: 7,486
Total Cats: 372
Awesome vid and autoX course - that's the kind of course that get's you doing track events for sure. When you get your new cam, you can mount the old one facing out back or in the nose or on the side... Nice job.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM