WTF burned another ignitor
#1
Elite Member
Thread Starter
iTrader: (3)
Join Date: Oct 2004
Location: lansdale PA
Posts: 2,494
Total Cats: 0
WTF burned another ignitor
i flashed to hi-res, ignitor disconnected the whole time, turned power off, plugged ignitor back in, load old map, start car.......barely started, no tach signal....to get a decent idle i pretty much had to double all of my VE table values, is that normal? i guess the adjustments made now are a smaller percentage thus higher resolution?
#3
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
keep the ignitor unplugged the entire time, and I always turn the ign off and back on after flashing too, just to be sure. the ms doesn't make all its changes until after a power cycle sometimes.
#4
Elite Member
Thread Starter
iTrader: (3)
Join Date: Oct 2004
Location: lansdale PA
Posts: 2,494
Total Cats: 0
i'm an idiot then that did it oh well, i shouldn't be working on the miata this tired. today i took off work since the heater/ac guys were coming, then decided to get some stuff done:
spark plugs, wires, cap, rotor, water pump on my truck
removed upper timing guides, replaced spark plugs, valve cover gasket on my 240sx
replaced 2 broken fence posts
then got to the miata and broke it
spark plugs, wires, cap, rotor, water pump on my truck
removed upper timing guides, replaced spark plugs, valve cover gasket on my 240sx
replaced 2 broken fence posts
then got to the miata and broke it
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM