and it begins
#1
I'm Miserable!
Thread Starter
iTrader: (5)
Join Date: Dec 2006
Location: jacksonville, fl
Posts: 1,711
Total Cats: -1
and it begins
just order to begin MS
MegaSquirt-I Programmable EFI System PCB3.0 - UnAssembled Kit
Lead Bending Tool
PCBv3 and v2.2 -- Pullup Resistors 'ModKit'
GM Open Element IAT Sensor with Pigtail
i will just leave the stock ecu in for fans and idle right now, i will add those to MS later after i get it in a working. i will just use the miata coolant temp sensor, do i need to cut the wire going to the ECU completly and run it to just MS, or can i tap it? i dont know if the stock ECU uses it or the coolant switch for idle controll. be prepared for a couple questions next week i have built 2 MS1 2.2 before, so i should be fine.
MegaSquirt-I Programmable EFI System PCB3.0 - UnAssembled Kit
Lead Bending Tool
PCBv3 and v2.2 -- Pullup Resistors 'ModKit'
GM Open Element IAT Sensor with Pigtail
i will just leave the stock ecu in for fans and idle right now, i will add those to MS later after i get it in a working. i will just use the miata coolant temp sensor, do i need to cut the wire going to the ECU completly and run it to just MS, or can i tap it? i dont know if the stock ECU uses it or the coolant switch for idle controll. be prepared for a couple questions next week i have built 2 MS1 2.2 before, so i should be fine.
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM