MSPNP2 cranks but wont start
#1
MSPNP2 cranks but wont start
hey guys so I got my mspnp all hooked up and I also wired an aem wideband when I installed it. I have the black and red wire tapped into the stock harness and I have the white wire in pin 21 of the options port on MS.
I tried cranking a couple times lastnight but it wouldn't start, shot a flame also, plugs 1 and 4 seemed pretty fouled. replaced all four spark plugs today and it still wont start.
here is a datalog of a few cranks and the tune. I am using the basemap with nothing changed except the aem wideband is set as custom linear WB. volts are 0-5 and afr is 10-20. please let me know.
CurrentTune.msq
log 2 startup.msl
startup 3.msl
tune is what im using. both logs are cranks from just now. two or three cranks on the last file make sure to scroll to end.
Any help is much appreciated guys I gotta get the car running asap.
Thanks, Nick
I tried cranking a couple times lastnight but it wouldn't start, shot a flame also, plugs 1 and 4 seemed pretty fouled. replaced all four spark plugs today and it still wont start.
here is a datalog of a few cranks and the tune. I am using the basemap with nothing changed except the aem wideband is set as custom linear WB. volts are 0-5 and afr is 10-20. please let me know.
CurrentTune.msq
log 2 startup.msl
startup 3.msl
tune is what im using. both logs are cranks from just now. two or three cranks on the last file make sure to scroll to end.
Any help is much appreciated guys I gotta get the car running asap.
Thanks, Nick
#2
UPDATE: not getting ignition to the cylinder 2&3 coil pack. tested the packs and they are firing, wires are fine, and plugs are brand new. is there a setting in Tunerstudio that could possibly cause no spark in 2&3?? what should I be looking for/testing.
Could use all the help in the world right now..
Thanks, Nick
Could use all the help in the world right now..
Thanks, Nick
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM