EBC data log and duty target tune help
#3
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
Without looking at the logs/files, did you notice any difference with the ebc? As in, is it working at all to produce boost over wastegate pressure?
My BEGi kit wouldn't make the boost I wanted until I adjusted the wastegate actuator arm tighter. It was just blowing open.
Post the boost duty targets here.
My BEGi kit wouldn't make the boost I wanted until I adjusted the wastegate actuator arm tighter. It was just blowing open.
Post the boost duty targets here.
#12
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
don't bother with that page. leave it at 70 across the board. if ebc is working the duty cycle table is what you should use.
1. make sure you don't have any boost leaks
2. make sure the boost control solenoid is wired properly. with car off but key on you should be able to hear the solenoid working when you press the gas.
3. make sure the boost control solenoid is plumbed correctly. the silver fitting goes to the boost source. the other goes to the actuator.
4. make sure your boost controller parameters are correct. 19.5 Hz, 20, 49.8, 9.8, Increase boost
1. make sure you don't have any boost leaks
2. make sure the boost control solenoid is wired properly. with car off but key on you should be able to hear the solenoid working when you press the gas.
3. make sure the boost control solenoid is plumbed correctly. the silver fitting goes to the boost source. the other goes to the actuator.
4. make sure your boost controller parameters are correct. 19.5 Hz, 20, 49.8, 9.8, Increase boost
Thread
Thread Starter
Forum
Replies
Last Post