831Mazderp

Hey all, I'm new to the MS game and attempting to run a Rev ms3 basic on my 99 usdm. I'm having issues getting tunerstudio to communicate with the ecu.

Ive installed the drivers and see the usb cord on com3.
When i attempt to to test the port in tunerstudios it fails and I get a no controller found and I'm in offline mode.
I figure the MS is getting power because my WBO2 is wired to the db37 and it's on.
The CEL and the battery light also flash and it won't start ; any recommendations on diagnosis would be greatly appreciated!

ryansmoneypit

iTrader: (6)

Try all of your USB ports. On my home pc, only 1 of 7 works.

831Mazderp

appreciate the response Ryan, tryed that but no dice. I'm hoping it's not on the hardware side, anyone know of resourses for diagnosing no communications?

831Mazderp

Gonna try this later hope it helps me or someone else .
http://www.megamanual.com/connect.htm