F/S t25 t28 Turbo Elbow
#10
My .02
Good luck with the sale.
-Ryan
#11
Don't be a dick. Maybe he had time constraints and couldn't spend the time writing up a novel. Likes like a 3" v-banded 304 stainless 90* elbow. Looking at the orientation of the mouth, looks to be a top mount. Now I am no expert, just an average Joe with eyes. I doubt its for a sidemount setup. (Again I am not claiming to be an expert) And who cares who made it, welds look solid, good penetration, and looks to be back purged.
My .02
Good luck with the sale.
-Ryan
My .02
Good luck with the sale.
-Ryan
#13
Junior Member
Thread Starter
iTrader: (1)
Join Date: Dec 2007
Location: Orlando,Fl
Posts: 402
Total Cats: 0
wow take it easy guys!! its only a damn downpipe. BTW i was on a time restraint i have a real job you know. Its meant for a bottom mount set up, 3" down pipe with 3" v-band. The person that welded it is the one that welds most of the stuff here at work, and yes it has been back purged. The downpipe was bought of off ebay i had this same downpipe in my last miata (see previous threads) never had any problems.
Thread
Thread Starter
Forum
Replies
Last Post