Custom aluminum intake manifold 99-05
02-14-2014, 09:43 PM
#1
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
Custom aluminum intake manifold 99-05
The manifold was made for me a while back but I have no use for it now. The runners are 6.5" long and the throttle body is 70mm with a matching flange. I used this on a built 99/00 motor so it should work fine on a 01-05 as well. $275
0
02-14-2014, 10:49 PM
#2
Junior Member
Join Date: Dec 2013
Posts: 53
Total Cats: 1
Looks nice. What is the runner diameter?
0
02-15-2014, 11:00 AM
#5
Senior Member
Join Date: Apr 2011
Location: Hollywood, FL
Posts: 807
Total Cats: 163
What does it weigh with TB attached? Provisions for tps and iac?
0
02-15-2014, 07:11 PM
#7
Senior Member
Join Date: Apr 2011
Location: Hollywood, FL
Posts: 807
Total Cats: 163
OK stupid question then, does a stock 1.8 TB bolt up? If not can it be drilled for new holes or would you have to weld in the existing holes and drill new ones?
And yeah, what was the intended rev range? Is peak torque somewhere around 4k?
And yeah, what was the intended rev range? Is peak torque somewhere around 4k?
0
02-15-2014, 09:11 PM
#8
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
This was built for maximum HP, but didn't seem to negatively effect torque on the dyno when we tested it. The stock TB will not bolt up to this as it is built to have the 70mm ford TB on there. You may be able to fit the stock one on there by re drilling, but that may create a bottleneck in itself.
0
Thread
Thread Starter
Forum
Replies
Last Post
