Who makes offset lower control arm bushings cheep?
#1
Elite Member
Thread Starter
iTrader: (11)
Join Date: Apr 2007
Location: VA Beach
Posts: 1,996
Total Cats: 51
Who makes offset lower control arm bushings cheep?
Looking for offset lower control arm bushings so I can get some more camber in the car.
I found them here:
Miata Suspension
But $80 but some little bushing
I found them here:
Miata Suspension
But $80 but some little bushing
#2
Made in the low volumes I'm sure ISC does, $80 isn't honestly a bad price for the time/effort to make them. That I've seen no one else currently makes any.
I made my own from Delrin bar stock and used the inner liners from the ES poly bushings that would have been in that spot. Total cost was just the Delrin at about $17. If you have any access to a lathe/mill or know someone who does that's the cheap way to do it.
I made my own from Delrin bar stock and used the inner liners from the ES poly bushings that would have been in that spot. Total cost was just the Delrin at about $17. If you have any access to a lathe/mill or know someone who does that's the cheap way to do it.
#3
Elite Member
Thread Starter
iTrader: (11)
Join Date: Apr 2007
Location: VA Beach
Posts: 1,996
Total Cats: 51
Made in the low volumes I'm sure ISC does, $80 isn't honestly a bad price for the time/effort to make them. That I've seen no one else currently makes any.
I made my own from Delrin bar stock and used the inner liners from the ES poly bushings that would have been in that spot. Total cost was just the Delrin at about $17. If you have any access to a lathe/mill or know someone who does that's the cheap way to do it.
I made my own from Delrin bar stock and used the inner liners from the ES poly bushings that would have been in that spot. Total cost was just the Delrin at about $17. If you have any access to a lathe/mill or know someone who does that's the cheap way to do it.
Want to make me a set or two?
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM