Engine built (BUILD) components
#1
Elite Member
Thread Starter
iTrader: (9)
Join Date: Sep 2008
Location: Michigan
Posts: 5,609
Total Cats: 13
Engine built (BUILD) components
My engine failed. I'm looking to have one built. If you have any components such as bearing, rods, main caps..etc. Please let me know.
Things I already have:
Pistons
TB/WP etc..
ARP Studs
However, due to a recent family urgency I'm low on funds.
Things I already have:
Pistons
TB/WP etc..
ARP Studs
However, due to a recent family urgency I'm low on funds.
Last edited by buffon01; 11-30-2010 at 11:56 AM.
#2
I have Carrillo a-beams that I have yet to put up f/s. They were in my motor that got the thrust bearing wiped out on, the rods are still good, no spun bearings, etc. They only have like 8 hours on them. They have a little tiny bit of brown "burnishing" in the small end bushing, maybe like 3/8" around, if you were ---- about it you could probably buff that out, otherwise they are as new. I was going to ask $600 incl ship to the lower 48, let me know. Granted, they are not cheap like an Eagle would be, but put side-by-side, I promise you'll see the difference in quality between Carrillos and anything else.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM