2002 VVT swap into 1990 NA with MS3
#65
As Curly said mentioned on my other inquiring post, I do have a Fidanza flywheel. He recommended just getting a new friction plate. That will save some funds.
I guess this is the part here.
Replacement Fidanza Flywheel Friction Surface for Miata 1990-1993
Do the other parts typically not need to be replaced? With a new clutch and friction plate would the noise/rattle quiet at all or is that par for the course?
I guess this is the part here.
Replacement Fidanza Flywheel Friction Surface for Miata 1990-1993
Do the other parts typically not need to be replaced? With a new clutch and friction plate would the noise/rattle quiet at all or is that par for the course?
#78
Here's a build thread of a few more posts and photos on gasp CR if anyone wants to see.
Oregonmon's white 1990 - ClubRoadster.net
Oregonmon's white 1990 - ClubRoadster.net
#79
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,433
Total Cats: 1,210
Aww, don't be lazy on us Ryan! Also, your image of the MS3 above is broken.
Pics for the MT crowd:
Pics were taken after we barely finished bolting it in, about 50% of the plumbing and wiring is done. All the pigtails for the CAS, CrankAS, IAC, TPS, COPs (x2), and VVT are all just laying in the back of the bay to be wired today and tomorrow.
Just waiting on a fuel rail and NA 1.8 pulley to bolt on to the 1.6 alternator before we can really finish.
We also decided to make the wiring pretty, so the TPS, IAC, and crank sensor wiring will all be slightly extended to run along the intake manifold, instead of hopping over by the throttle body.
Pics for the MT crowd:
Pics were taken after we barely finished bolting it in, about 50% of the plumbing and wiring is done. All the pigtails for the CAS, CrankAS, IAC, TPS, COPs (x2), and VVT are all just laying in the back of the bay to be wired today and tomorrow.
Just waiting on a fuel rail and NA 1.8 pulley to bolt on to the 1.6 alternator before we can really finish.
We also decided to make the wiring pretty, so the TPS, IAC, and crank sensor wiring will all be slightly extended to run along the intake manifold, instead of hopping over by the throttle body.