build thread (TII drivetrain swap, built motor, cage, widebody, blah blah)
#523
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
Also, to update my "blowing oil out of the valve cover" issue i was having, I went to drain my catch can last night after having run 2 tanks of fuel through the car, and not a single drop came out- it's bone dry. This confirms that the only reason it was leaking in the first place was the poor job I did sealing the baffles on the old valve cover.
#525
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
Put some heat shielding on the underside of the hood, as well as on 2/3s of the brake reservoir (Thanks Revlimiter for the link!!). I left the section facing the fender open so I can still check the fluid level.
Went for a spin after work and took a few pics with my phone. I'll post one for now...
Went for a spin after work and took a few pics with my phone. I'll post one for now...
#527
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
I bought 8 sheets. I did the hood, and I plan on lining the trans tunnel as it gets pretty hot in the cabin after a long drive (go figure)
#531
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
Did some trimming and lowered the car a bunch. Crappy iphone, poorly lit, garage pics until tomorrow when I can actually have room to take some halfway decent ones. Ignore the dust all over the car, I'm going to wash it tomorrow
Again, sorry for the poor quality.
Again, sorry for the poor quality.