Miata Turbo Forum - Boost cars, acquire cats.
Page 3 of 3
1
2
3
Show 60 post(s) from this thread on one page

Miata Turbo Forum - Boost cars, acquire cats. (https://www.miataturbo.net/)
-   DIY Turbo Discussion (https://www.miataturbo.net/diy-turbo-discussion-14/)
-   -   Affordable tial Vband housing? (https://www.miataturbo.net/diy-turbo-discussion-14/affordable-tial-vband-housing-38135/)

rharris19 08-14-2009 07:26 PM
You can borrow my lemons car if you want for your race. It's real nice

SKMetalworks 08-14-2009 07:33 PM
Jeeze. I also need the 38mm WG lol

ARTech 08-14-2009 08:14 PM
Tial calls it a gt25/gt28 housing

TiAL Sport.com

Tim, have you tried to mate it to a gt25. The wheel exducer is the same diameter, the inducer is only .8mm smaller. 53mm vs 53.8mm, but that's not important. As far as I'm concerned gt25/gt28's use the same turbine housing.

aznDragonX 08-14-2009 08:31 PM
hmm..I am thinking about getting one now. If I can use it for both GT25 and GT28. I am planning to upgrade to GT2871R later

CRXican 08-14-2009 08:42 PM
fuuuuuu

The Absurdflow downpipes alone are so sexy and with the Vbands thrown in. Time to save them pennies.

TurboTim 08-14-2009 10:27 PM
Originally Posted by Spookyfish (Post 442656)
Tim, I might be in for a kit. But I mean a kit: turbo, manifolder, flanges, bands, the works. And I expect it to align to my cat exactly where/how my current dp ends. Basically what Hustler has me thinks...

Would that work?
Yep. You have to deal with oil drain and a solution for the lower radiator hose.

TurboTim 08-14-2009 10:33 PM
Originally Posted by sprayed (Post 442684)
Tial calls it a gt25/gt28 housing

TiAL Sport.com

Tim, have you tried to mate it to a gt25. The wheel exducer is the same diameter, the inducer is only .8mm smaller. 53mm vs 53.8mm, but that's not important. As far as I'm concerned gt25/gt28's use the same turbine housing.
Noooo nonono noooo exducer is wayyy different diameter. About a 1/4 inch eyeballing it (I didn't measure each when I had them both..dumb). Looks like the Garrett casting is the same for both, but the machining for the turbine wheel is different, at least.

I'm think you (I) can machine a v-band out of a T2 inlet, but in that case you'd still be stuck with the standard outlet and cast iron.

ARTech 08-14-2009 11:27 PM
You're right, sorry for getting everyones hopes up. GT2560= 2.09” inducer/ 1.64” exducer, GT2860= 2.12” inducer/ 1.85” exducer

What's the deal with Tial? I've seen the same thing advertised as gt25/28 on several other websites...copied from theirs I'm sure.


All times are GMT -4. The time now is 07:55 AM.
Page 3 of 3
1
2
3
Show 60 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands