COP Success!
#1
I'm Miserable!
Thread Starter
iTrader: (1)
Join Date: Oct 2005
Location: Columbia, SC
Posts: 853
Total Cats: 1
COP Success!
I've had the parts for I dunno...2-3 months or so but I finally got around to installing them today. Went to a local miata guy and picked up a spare set of coils to use the connector. Cutting through that epoxy is a pain in the ***. After I soldered the wires to the old coil connectors, I re-epoxied. Wires going to the coil connectors are expoxied as well.
Took about 3hrs to get everything wired up nice. Still havent fabbed a hold-down for it but that should take all of 20 minutes. Started right up on the first crank!
I guess the F/IC doesnt seem to mind them at all. Havent gone for a real "ride" yet b/c the COP's would probably jump around too much and freak me out.
Thanks Braineack for the write-up.
Took about 3hrs to get everything wired up nice. Still havent fabbed a hold-down for it but that should take all of 20 minutes. Started right up on the first crank!
I guess the F/IC doesnt seem to mind them at all. Havent gone for a real "ride" yet b/c the COP's would probably jump around too much and freak me out.
Thanks Braineack for the write-up.
#4
I'm Miserable!
Thread Starter
iTrader: (1)
Join Date: Oct 2005
Location: Columbia, SC
Posts: 853
Total Cats: 1
quick pic:
underside of the "bracket" has dense foam stuff. I welded a 14mm bolt to the top of the 10mm valve cover bolt, fastened on the "bracket" with a 14mm bolt and a rubber bushing
underside of the "bracket" has dense foam stuff. I welded a 14mm bolt to the top of the 10mm valve cover bolt, fastened on the "bracket" with a 14mm bolt and a rubber bushing
Thread
Thread Starter
Forum
Replies
Last Post