Dear MT, oil and coolant leakkkzzzz
#1
Elite Member
Thread Starter
iTrader: (6)
Join Date: Sep 2010
Location: Seattle, WA
Posts: 3,611
Total Cats: 25
Dear MT, oil and coolant leakkkzzzz
Dear MT.net,
I am dealing with two leakzzzz, one coolant, one oil.
My coolant is leaking steadily and visibly. I am worried that it is my heater core - see picture below. It is leaking from behind the wheel well, and I cannot figure out what else it could be.
Secondly, I am dealing with an oil leak. I am using Abe's SS kit for coolant and oil - oil is leaking from the feed steadily. I tightened it down untill it felt snug, but not tight with a wrench (Inch lbs of torque at best - MAYBE mid-single digit ft lbs). Do I need to tighten the AN lines more than that? Note that the oil is coming from the fitting-fitting connection, not the fitting-block connection.
I am dealing with two leakzzzz, one coolant, one oil.
My coolant is leaking steadily and visibly. I am worried that it is my heater core - see picture below. It is leaking from behind the wheel well, and I cannot figure out what else it could be.
Secondly, I am dealing with an oil leak. I am using Abe's SS kit for coolant and oil - oil is leaking from the feed steadily. I tightened it down untill it felt snug, but not tight with a wrench (Inch lbs of torque at best - MAYBE mid-single digit ft lbs). Do I need to tighten the AN lines more than that? Note that the oil is coming from the fitting-fitting connection, not the fitting-block connection.
#4
http://thefactoryfiveforum.com/archi...hp/t-453.html?
Here ya go. About half a turn past finger tight according to this
Here ya go. About half a turn past finger tight according to this
#6
Elite Member
Thread Starter
iTrader: (6)
Join Date: Sep 2010
Location: Seattle, WA
Posts: 3,611
Total Cats: 25
http://thefactoryfiveforum.com/archi...hp/t-453.html?
Here ya go. About half a turn past finger tight according to this
Here ya go. About half a turn past finger tight according to this
Yes, there is two coolant leaks. One in the engine bay, and one that has it leaking from the wheel well.
#7
Elite Member
Thread Starter
iTrader: (6)
Join Date: Sep 2010
Location: Seattle, WA
Posts: 3,611
Total Cats: 25
Update: Oil fitting was undertightened, other fittings were undertightened, causing all the leaks but one.
Picture included where the final coolant leak is. It is leaking from the circled area - bad hose?
Picture included where the final coolant leak is. It is leaking from the circled area - bad hose?
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM