Double checking ECU wires for O2 clamp...
Thread Starter
Senior Member
iTrader: (3)
Joined: Apr 2006
Posts: 900
Total Cats: 0
From: Northern Michigan
Double checking ECU wires for O2 clamp...
I really don't want to screw this up and I won't get much time to start and finish it. I plan on running a boost line to the ecu, I don't want to run a long O2 wire, I have had trouble in the past with this.
Is this correct for a 91?
The O2 wire at the ecu is Red with a Blue strip. (it is 2N, but connector 2 doesn't go up to the letter N!?)
The ground are the two wires on the very far right edge of the connector 2 facing the ecu.
The switching 12v wire is the far right bottom wire facing the ECU.
I am dumb, I already know, but rip on me if you want to anyways.
Is this correct for a 91?
The O2 wire at the ecu is Red with a Blue strip. (it is 2N, but connector 2 doesn't go up to the letter N!?)
The ground are the two wires on the very far right edge of the connector 2 facing the ecu.
The switching 12v wire is the far right bottom wire facing the ECU.
I am dumb, I already know, but rip on me if you want to anyways.
Reply
0
0
Reply
0
0
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
unplugged92
Engine Performance
17
Apr 8, 2015 07:12 AM
