Water line newb question
#1
Elite Member
Thread Starter
iTrader: (6)
Join Date: Sep 2007
Location: CA
Posts: 2,016
Total Cats: 13
Water line newb question
When using stainless steel lines for the water lines, how do you attach the screw-on type fitting of the stainless line to the waterpump/thermostat slip-on type fitting?
Does the stock slip-on fitting at the waterpump/thermostat unscrew out?
Thanks
Does the stock slip-on fitting at the waterpump/thermostat unscrew out?
Thanks
#2
The steel OEM nipples are pressed into the castings. The won't come out easily. The way to do it is to buy a fitting with a hose barb on one end and an A/N fitting on the other.
Splice it into the rubber hose where it is convenient and away from the heat. From that point use your braided line to the turbo.
KMag
Splice it into the rubber hose where it is convenient and away from the heat. From that point use your braided line to the turbo.
KMag
#3
I used hydraulic line to a banjo fitting with a hose barb at the turbo. Line size was different.
Just put together a fitting that has hosebarbs on either side that steps down from the hose size at the turbo to the OEM fittings. All you need is a coupler and two hose bards, for each line.
Just put together a fitting that has hosebarbs on either side that steps down from the hose size at the turbo to the OEM fittings. All you need is a coupler and two hose bards, for each line.
Last edited by jayc72; 07-09-2008 at 04:33 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM