The washer fluid bottle on the NA ABS cars is relocated to the front bumper area. Has anyone had trouble routing their I/C piping on the hotside because of this? Looks a little tight, but I've yet only given it a quick look.

People with ABS care to chime in?

Jay

 

I've had three different IC setups with the front washer bottle without a problem so I can't imagine that it'd be an issue UNLESS you are trying the over the rad and into the holes where the washer fill spout comes up.

 

Thanks Tom.

 

i went right under it, no issues:



you could also be dumb like me and use a huge 180° bend.

 

I took mine off for ease of install, never got around to putting it back in.. but it will fit tightly.

 

Had to remove mine because it interfered with the intercooler pipe routing on my BEGI S-2 system. I asked Corky if he had any suggestions and shortly afterwards I find this in the mail. Haven't installed it yet but it sure is pretty. I'm sure if you needed it he could fab something up.