Guys all my bookmarks are gone and I had a bunch of sites that had intercoolers (by size and config) any links? THanks

 

http://cxracing.com/
18 x 6 x 3 seems to be the most favorable one. ( i have one too) According to braineak it seems good for up to 366hp

 

I did not see that size listed on their site.....

 

http://www.cxracing.com/mm5/merchant...ry_Code=IC30CO

is what I think he meant

 

when they sell on ebay, it sometimes comes out $10-20 cheaper.

 

on eBay: cxmotorsports, cxracing, just-intercoolers

 

i need more links

 

ya my bad its 18x12x3

 

http://www.cxracing.com/mm5/merchant...gory_Code=INCO

I need that one but not as long. ie <24inches

 

here's the big one that fits with the a/c drier

the smaller one that centers up in the mouth

 

I can gaurantee a 24" ic will fit in front of the radiator, with a/c. Mine is 17" core but 24" WOA, with pipes around the radiator like Stripes and Braineack.
are you going under the radiator or over? or v mount?

Rob, does that big 25x12x3 ic fit between the stock hood latch and mouth funnel?

 

duuuude you didnt even look.

Over I need the inlet/outlet on the same side.

 

duuuuude I did look, that's why I asked if you were going over, under, or v mount

 

I wasnt talking about you fooo

 

Philip, can we re-name this smiley treunos?

 

Loki,

I think the one you want is the same as I bought from CXracing off ebay. They don't have every model on the website. Several times I've seen ones similar to the 12x18 but with one side inlet/ outlets. That's what I bought and will be running over the top of the rad. The one I got was one side, 2.5" inlet and outlet, 3" thick with a 10" x 11" core.

Email them what you want. They likely have more of them. It's an oddball so they don't advertise it often and charge a buttload for it.

 

Shouldn't that be truenosluv?

 

ben - I don't know, I don't have a hood latch. But it's the same height as the narrow one so it should work.

 

http://stores.ebay.com/Just-Intercoo...QQftidZ2QQtZkm

Just intercoolers

Check my build thread and check out the EVO IC I stuffed in mine. It's 24x12x3.5 (3.5 thick I think)

 

I went out and measured. A 24x12 looks like it would fit under the hood latch if it is pushed back as close to the radiator as possible.

My ic is a couple inches forward of the radiator. Looks like I could get maybe a 4" taller core in there. One of BEGI's 18x9x3 cores would be perfect. But I think they get on the order of $700 for it.