Compressor Flange Types
#1
Compressor Flange Types
I've been wondering for a very long time...what's the technical term for the 2 and 3 bolt flanges that are on the inlet and outlet of some compressor housings?
I've seen identical turbos with those flanges and with the machined tube fittings, yet I don't think I've ever seen any options to choose between the two when purchasing a turbo.
I've seen identical turbos with those flanges and with the machined tube fittings, yet I don't think I've ever seen any options to choose between the two when purchasing a turbo.
#2
Senior Member
iTrader: (4)
Join Date: Jan 2008
Location: Falls Church, VA
Posts: 1,361
Total Cats: 17
I haven't ever seen them called anything other than a 2-bolt inlet or a 3-bolt outlet. If you see a turbo advertised as a direct drop-in upgrade for a Nissan OEM turbo, that usually means it will have those flanges. Garrett sells a bunch of different 2871 turbos and you can get them with either that pattern or the bare slip-on style (and different wheel combinations) depending on part number. You can also buy adapters for the 2 & 3-bolt flanges, so there are options to deal with either.
#3
Thanks for clearing that up. It sounds like Nissan used those flanges to bolt right onto the intake piping...it's probably a better connection than a worm clamp, especially when used at an OEM level.
I've seen the adapters, but I'd imagine it could create some spacing issues just from the bulk of the flanges.
I've seen the adapters, but I'd imagine it could create some spacing issues just from the bulk of the flanges.
#5
Do newer turbo cars use t-bolt clamps on their piping? If not, then what? I haven't taken apart anything turbocharged made in the last decade.
It also brings up another question: It seems like most everyone has issues with turbo-to-downpipe nuts loosing up after track use or whatever on their aftermarket setups, yet I've never heard of this being an issue for the OEMs. I mean, look at those fancy Stage 8 locking fasteners FM recommends...I can't see manufacturers using something like that.
It also brings up another question: It seems like most everyone has issues with turbo-to-downpipe nuts loosing up after track use or whatever on their aftermarket setups, yet I've never heard of this being an issue for the OEMs. I mean, look at those fancy Stage 8 locking fasteners FM recommends...I can't see manufacturers using something like that.
#6
It also brings up another question: It seems like most everyone has issues with turbo-to-downpipe nuts loosing up after track use or whatever on their aftermarket setups, yet I've never heard of this being an issue for the OEMs. I mean, look at those fancy Stage 8 locking fasteners FM recommends...I can't see manufacturers using something like that.
#7
Elite Member
iTrader: (9)
Join Date: Jun 2006
Location: Chesterfield, NJ
Posts: 6,898
Total Cats: 399
The GT2560R's from FM have the flanges machined off, I think BEGI just welds a piece of pipe to the flange area. At some point (maybe still) FM/BEGI sourced these turbos from Limit Engineering who did the machine work. Many years ago I got my 2560 directly from limit with these flanges machined into 2.5" inlet and 2" outlet. It does make it a little easier to fit things, but I had to pay extra for it. At the time I didn't know where to get the pieces that bolt to the flanges. Now you can get them from ebay or ATP in all sorts of sizes.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM