Ignore the torque number, seems like it should be around 185-190 from around 4-4,700 rpm, just a weird torque spike in this run. It was very hard to get a smooth run in.
Mods
95 rebuilt engine with DIY polished head
T3 50 trim chinacharger, not very healthy
38mm EWG
tacotaco t3 manifold
2.5" mild steel exhaust
peak boost at around 3300 rpms, which is 11.5 psi

 

Nice numbers man. What's the smoothing set to in virtual dyno? Looks like you could bump it up another number to get rid of the waves.

 

not sure about the actual numbers, but the curves look correct.

 

I didn't smooth anything at all, I had another run that was much smoother but got cut off because a fourth gear pull needs a very long road. I'll play around with VD more and see if I can smooth it out and repost.

 

Should I really be hitting peak torque at around 5.3k? It seemed with most other t3 chinacharger dyno's around me they saw similar numbers. I know on your thread you got higher numbers than me. If it warms up I'll see what I can get in for runs.

 

i bet if you really dynoed it would look like this: