mpheinitz

Naturally aspirated stock internals NB Miata and Greddy Emanage Ultimata with no tuning, all zeros for I/J and ignition maps. I want to raise the rev limiter cut from stock 7200 to 7500 or higher.

I assume the values in the Rev Limiter Cut Settings can remain zero since I am not changing the stock values. ?

And am I safe to assume that anything over stock rev limit will use the last values (only two collumns) regardless of how high the rpm limit is set?

Mike

mpheinitz

ok, I think i figured it out. I need to datalog to determine inj duty cycle as the rev limit table supposedly does not rely on the main inj maps.

Mike

Lokiel

This is what our EMUs look like in Australia:



As an Aussie, I can probably give you a few pointers on them since I've seen quite a few in my time.

Best advice is not to run into them.