LINK display not working
#1
LINK display not working
New to LINK management systems. My display (the little box connected to the ribbon cable) stopped displaying. I actually have 2 boxes and they do the same thing. If I unplug the box while the engine is running and reconnect, I will get about 6 black squares on the display. It used to work just fine. For a while I had some display issues and then they went away. Nowthey are back. I looked at where the ribbon cable goes into the ECU and it doesnt have a connector on the ECU but goes under the ECU cover into the ECU. Is that normal?
Any help is appreciated.
Thanks,
Bobby
Any help is appreciated.
Thanks,
Bobby
#8
It used to work when connected before starting the car. Now I get nothing but the lights on the buttons illuminated. When i disconnect and reconnect while the car is running, I get the black boxes. This happens on both keypads that I have. I am going to replace the ribbon cable as suggested earlier to see if this corrects the issue. Any other suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM