Help with lc-1 and megasquirt
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2011
Location: Albuquerque, NM
Posts: 380
Total Cats: -14
Help with lc-1 and megasquirt
Bought a car with ms and the wideband.
Well first my innovation db gauge is just blinking 7.4. I've looked for the led but there isnt one. Bad sensor?
Also on the pnp megasquirt where would I connect the output wire? I've been searching and can't figure it out.
I've been searching but haven't found a answer.
Thanks.
Well first my innovation db gauge is just blinking 7.4. I've looked for the led but there isnt one. Bad sensor?
Also on the pnp megasquirt where would I connect the output wire? I've been searching and can't figure it out.
I've been searching but haven't found a answer.
Thanks.
#2
Try connecting to the LC-1 with LogWorks (it can be downloaded from Innovate's site if you don't have a copy). It will give you any error codes.
Usually with a DB gauge the two analog output wires are programmed to identical output curves, so one goes to the MS, one to the gauge, and it doesn't matter which is which.
Usually with a DB gauge the two analog output wires are programmed to identical output curves, so one goes to the MS, one to the gauge, and it doesn't matter which is which.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Johnny Tater
MSPNP
1
09-27-2015 12:38 AM