Hi guys just picked up an Lc-1 with a Xd16 Gauge today to replace a pos wideband i did have. i got it installed and working correctly using the provided documentation, my only question is can i change the refresh frequency on the gauge so its not bouncing around all the time. sorry if this has been covered before, quick search didnt come up with much.
Thanks

 

Yes, hook up your laptop to the LC-1 and load the LM programmer.

 

didnt it come with an install manual?

 

it came with both the lc-1 manual and xd-16 manuals in pdf form, and i looked through them while i was programing it originally. i saw that there was a time delay option for the outputs off the lc-1 but didnt think it would effect the gauge.

 

I acutally dont see a refresh rate in the display options, you want the controller to stay as fast as possible, that's the benefit of the innovate (fast *** refresh rates).

if it's bouncing all over, then your tune needs some fine tuning to smooth it out.

if you set the controller to a slow repsonse rate, it actually averages the data before it outputs.

 

from lm programmer the only thing you can change related to refresh are the two analog outputs off the lc1 itself. so some fine tunning will help, i planed on doing that today anyway.