MrSauce

iTrader: (1)

I have recently aquired a 99 bp4w with harness and a Perfect Power XMSV3 ECU. I would like to use the NB engine harness so that i can rewire it to the XMS and remove all unnecessary wires. I drive my car regularly so removing the factory 1.6 harness to trim it down and rerout it is not an option.
If i could find a complete ecu pinout for a 99/00 ECU i believe i could get everything up and working. I will not be running AC or PS so this simplifies the install a little bit.
I am open to advise or suggestions, if someone knows from experience that its will be better to start with somehting else im not opposed to it. The ECU has lots of functions and should be more then adequet for my setup and I like making harnesses so i will just ask that you not say "buy an MS3" That does not help me in any way.

bahurd

iTrader: (8)

I suspect you'll need more than the NB harness but nonetheless, good luck. And by the way.... Google is your friend

http://www.mellens.net/mazda/mazda_m...999_wiring.pdf You don't need the exact page to look for do you?

MrSauce

iTrader: (1)

I did spend a good bit of time google searching for a pinout with no luck, guess i should have tried diagram. Thanks a million thats exactly what i needed.
Of course i will need to add some wires to the harness for coil on plug and a few other things but theres a lot more being removed then added. I do have a second car so this car does not have to be entirely street friendly even though it will be a street car.