WBo2 & MiataLink EMS
Thread Starter
Junior Member
iTrader: (10)
Joined: May 2010
Posts: 106
Total Cats: -3
From: Gainesville, GA
WBo2 & MiataLink EMS
I just got a Autometer Sport Comp WBo2 & I am running the OLD (not sure exactly which model) MiataLink EMS. Is there any way to connect the WBo2 to the old MiataLink system & is there any programming necessary to make it work correctly with the WBo2? I am not very versed in EMS installation or anything to do with them so just answer like I'm the NOOB that I am...
It's pathetic, I know.
It's pathetic, I know.
Reply
0
0
Senior Member
Joined: Nov 2007
Posts: 999
Total Cats: 73
From: Belgium
Depends what version you have. The manuals are up on http://flyinmiata.com/support/ecu.php. You need the 90-93 instructions.
A bit lower on that page are instructions for the old Link mark I.
If you're not sure what version you have, check the chip version on the keypad and compare to the software revisions page on flyinmiata. Or, open the ecu and look what your circuit board looks like.
A bit lower on that page are instructions for the old Link mark I.
If you're not sure what version you have, check the chip version on the keypad and compare to the software revisions page on flyinmiata. Or, open the ecu and look what your circuit board looks like.
Reply
0
0
Senior Member
Joined: Nov 2007
Posts: 999
Total Cats: 73
From: Belgium
Can't edit - surfing through anonymous proxy.
This might be of help as well: http://flyinmiata.com/support/index.php
This might be of help as well: http://flyinmiata.com/support/index.php
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
